AUDIOLINE WAVE 10X Informazioni Techniche Scaricare il pdf (Pagina 105)

Clear CMOS Request Jumper (J7E1)

Notes

To set, change, or delete a password, see

“System Security” on page 21.

 If enhanced security is enabled, and you forget or

lose the administrator password, you must

replace the system board in the server to regain

access to the Configuration/Setup Utility program.

For more information, see “Using the Enhanced

Security Features” on page 24.

 Clearing CMOS memory erases the configuration

of the server. Therefore, you must reconfigure

the server after clearing CMOS memory. If

possible, record the server configuration

information

before

moving the CMOS jumper.

To reset CMOS, do the following.

1. Locate the

Clear CMOS Request

jumper (J7E1) on

the system board.

2. Move the jumper from its normal position (pins 1 and

2) to pins 2 and 3. It might be helpful to use

needlenose pliers to move the jumper, but be careful

not to crush the jumper or to scrape any

system-board components.

3. Reinstall the server cover and reconnect the cables

(see “Completing the Installation” on page 56 for

instructions).

4. Power-on the server back on for approximately 10

seconds.

Caution

Do not touch any components while power is on.

5. Power-off the server. CMOS memory is now cleared.

Note

You might not be able to turn off the power using

the power switch until POST is nearly complete.

Unplug the power cord to turn off the server.

IBM Netfinity 3500 - Type 8644 97

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 151 152

Nessun commento

AUDIOLINE WAVE 10X Informazioni Techniche Pagina 105